“LO C” on a Classic Sub-Zero display means the control panel is locked. Sub-Zero's manual explains it appears when the door switch reports the door as closed but control panel keys are being touched, or when a door was left open more than five minutes. The lights and control panel stop responding. The underlying cause is usually the door switch or its wiring, which a technician should check; the manual also gives a key sequence to unlock the panel after power is restored.
What Triggers LO C
The Classic control uses the door switch to know whether a door is open. You can only touch the panel with the door open, so if the switch says “closed” while keys are being touched, the control assumes something is wrong and locks the panel. The same lock is listed for a door left open more than five minutes. The troubleshooting guide pairs LO C with no lights and an inoperative control panel.
How Sub-Zero Says to Unlock It
Safe for homeowners
- Make sure doors close normally and nothing is holding a door switch.
- Disconnect power to the refrigerator at the breaker (or unplug it if accessible), then reconnect.
- Within five minutes of power-up, touch and hold ALARM and touch either COLDER key twice.
If LO C returns, the door switch or its wiring needs service.
Leave to a technician
Checking the door switch and the wires between the switch and the control board, and replacing a defective switch. This is behind panels with line voltage present.
Sources
- Sub-Zero Built-In (BI) Classic Series Technical Service Manual, #7040317, Revision A, September 2015 — pp. 2-35, 7-11, 7-14. Covers: BI-30U, BI-36U/UID/UFD/UFDID, BI-36F, BI-36R, BI-36S, BI-42S/SD/SID, BI-42UFD/UFDID, BI-48S/SD/SID, from serial #4380000.
Sub-Zero service manuals are written for certified technicians. We summarize them in our own words for homeowners and do not reproduce them. Procedures that involve electrical testing, the sealed system or refrigerant are intentionally left out of this page. Model coverage and serial ranges differ between documents, so always match your model and serial number. About our sources
Schedule Sub-Zero Repair in Las Vegas
$75 service call, credited toward your repair · 1-year parts · 180-day labor warranty · EPA 608 certified · Mon–Fri 8am–7pm · Sat–Sun 8am–4pm