On Classic Sub-Zero models, “--” in place of one compartment temperature means that zone has been turned off with Manual Zone Disable; it stays off through power outages until it is re-enabled. “OFF” means the whole unit was switched off with the POWER key. Briefly seeing “--” and then a model code right after power is restored is the normal power-up test. On the original 700 Series, “--” means the control is shut off.
What You're Seeing
| Display | Meaning | Fix |
|---|---|---|
| “--” briefly, then a model code, after power returns | Normal power-up diagnostic test (Classic) | None |
| “OFF” | Unit switched off with POWER; power is still present | Touch POWER for one second |
| “--” in place of one zone's temperature | That zone is disabled (Manual Zone Disable); its alarm is also inactive | Re-enable the zone (below) |
| “--” (original 700 Series) | Control is shut off | Press COLDER to start |
| Blank display | No power, reversed outlet polarity, or a broken display cable (Classic guide) | Check breaker; then call |
Re-Enabling a Disabled Zone (Classic)
Safe for homeowners
- Switch the unit off with the POWER key (“OFF” appears).
- Touch and hold the WARMER key for the disabled zone, then touch POWER, and release.
- Check your set-points once temperatures return.
Sub-Zero notes the disabled state is saved in memory, so a power outage will not undo it. People sometimes disable a zone for cleaning or defrosting and forget.
If the display is blank, the Classic guide lists no power, reversed electrical outlet polarity (an electrician's fix) and a broken or disconnected communication wire between the control board and control panel. See Sub-Zero not turning on.
Sources
- Sub-Zero Built-In (BI) Classic Series Technical Service Manual, #7040317, Revision A, September 2015 — pp. 2-6, 2-15, 7-12 to 7-14. Covers: BI-30U, BI-36U/UID/UFD/UFDID, BI-36F, BI-36R, BI-36S, BI-42S/SD/SID, BI-42UFD/UFDID, BI-48S/SD/SID, from serial #4380000.
- Sub-Zero Electronic Control Pocketbook (Pocket Manual) — p. 64. Covers: 400/400-2 wine, 427R, 600/600-2, 700/700-2/700-3, 648PRO, UC Series controls.
Sub-Zero service manuals are written for certified technicians. We summarize them in our own words for homeowners and do not reproduce them. Procedures that involve electrical testing, the sealed system or refrigerant are intentionally left out of this page. Model coverage and serial ranges differ between documents, so always match your model and serial number. About our sources
Schedule Sub-Zero Repair in Las Vegas
$75 service call, credited toward your repair · 1-year parts · 180-day labor warranty · EPA 608 certified · Mon–Fri 8am–7pm · Sat–Sun 8am–4pm